Edge-Core ECS4210-12P - Mvr Associated-Profile

Chapter 22 | Multicast Filtering Commands
Multicast VLAN Registration
– 581 –
mvr This command enables Multicast VLAN Registration (MVR) globally on the switch.
Use the no form of this command to globally disable MVR.
Syntax
[no] mvr
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If MVR
must be configured for an IGMP version 1 host, the multicast groups must be
statically assigned using the mvr vlan group command.
Example
The following example enables MVR globally.
Console(config)#mvr
Console(config)#
mvr associated-profile This command binds the MVR group addresses specified in a profile to an MVR
domain. Use the no form of this command to remove the binding.
Syntax
[no] mvr domain domain-id associated-profile profile-name
domain-id - An independent multicast domain. (Range: 1-5)
profile-name - The name of a profile containing one or more MVR group
addresses. (Range: 1-21 characters)
Default Setting
Disabled
Command Mode
Global Configuration
Example
The following an MVR group address profile to domain 1:
Console(config)#mvr domain 1 associated-profile rd
Console(config)#