Chapter 5
| SNMP Commands
General SNMP Commands
– 153 –
General SNMP Commands
snmp-server This command enables the SNMPv3 engine and services for all management clients
(i.e., versions 1, 2c, 3). Use the no form to disable the server.
Syntax
[no] snmp-server
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console(config)#snmp-server
Console(config)#
snmp-server
community
This command defines community access strings used to authorize management
access by clients using SNMP v1 or v2c. Use the no form to remove the specified
community string.
Syntax
snmp-server community string [ro | rw]
no snmp-server community string
string - Community string that acts like a password and permits access to
the SNMP protocol. (Maximum length: 32 characters, case sensitive;
Maximum number of strings: 5)
ro - Specifies read-only access. Authorized management stations are only
able to retrieve MIB objects.
rw - Specifies read/write access. Authorized management stations are able
to both retrieve and modify MIB objects.
Default Setting
â—† public - Read-only access. Authorized management stations are only able to
retrieve MIB objects.
â—† private - Read/write access. Authorized management stations are able to both
retrieve and modify MIB objects.
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General
