Chapter 4
| System Management Commands
Switch Clustering
– 146 –
Example
Console(config)#cluster
Console(config)#
cluster commander This command enables the switch as a cluster Commander. Use the no form to
disable the switch as cluster Commander.
Syntax
[no] cluster commander
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆ Once a switch has been configured to be a cluster Commander, it automatically
discovers other cluster-enabled switches in the network. These “Candidate”
switches only become cluster Members when manually selected by the
administrator through the management station.
◆ Cluster Member switches can be managed through a Telnet connection to the
Commander. From the Commander CLI prompt, use the rcommand id
command to connect to the Member switch.
Example
Console(config)#cluster commander
Console(config)#
cluster ip-pool This command sets the cluster IP address pool. Use the no form to reset to the
default address.
Syntax
cluster ip-pool ip-address
no cluster ip-pool
ip-address - The base IP address for IP addresses assigned to cluster
Members. The IP address must start 10.x.x.x.
Default Setting
10.254.254.1
To Next Page
Loading...
