Chapter 23
| LLDP Commands
– 611 –
Command Usage
This option advertises MAC/PHY configuration/status which includes information
about auto-negotiation support/capabilities, and operational Multistation Access
Unit (MAU) type.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot3-tlv mac-phy
Console(config-if)#
lldp dot3-tlv
max-frame
This command configures an LLDP-enabled port to advertise its maximum frame
size. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv max-frame
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Refer to “Frame Size” on page 102 for information on configuring the maximum
frame size for this switch.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv max-frame
Console(config-if)#
lldp dot3-tlv poe This command configures an LLDP-enabled port to advertise its Power-over-
Ethernet (PoE) capabilities
12
. Use the no form to disable this feature.
Syntax
[no] lldp dot3-tlv poe
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
12. ECS4210-12P, ECS4210-28P
To Next Page
Loading...
Need help?
General
