Edge-Core ECS4210-12P - Dot1 X Timeout Start-Period

Chapter 7 | Authentication Commands
802.1X Port Authentication
– 231 –
dot1x timeout
start-period
This command sets the time that a supplicant port waits before resending an
EAPOL start frame to the authenticator. Use the no form to restore the default
setting.
Syntax
dot1x timeout start-period seconds
no dot1x timeout start-period
seconds - The number of seconds. (Range: 1-65535)
Default
30 seconds
Command Mode
Interface Configuration
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout start-period 60
Console(config-if)#
Display Information Commands
show dot1x This command shows general port authentication related settings on the switch or
a specific interface.
Syntax
show dot1x [statistics] [interface interface]
statistics - Displays dot1x status for each port.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
Command Mode
Privileged Exec
Command Usage
This command displays the following information:
◆ Global 802.1X Parameters – Shows whether or not 802.1X port authentication is
globally enabled on the switch (page 221).