Chapter 22
| Multicast Filtering Commands
Multicast VLAN Registration
– 591 –
show mvr This command shows information about MVR domain settings, including MVR
operational status, the multicast VLAN, the current number of group addresses, and
the upstream source IP address.
Syntax
show mvr [domain domain-id]
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays configuration settings for all MVR domains.
Command Mode
Privileged Exec
Example
The following shows the MVR settings:
Console#show mvr
MVR Proxy Switching : Enabled
MVR Robustness Value : 1
MVR Proxy Query Interval : 125(sec.)
MVR Source Port Mode : Always Forward
MVR Domain : 1
MVR Config Status : Enabled
MVR Running Status : Active
MVR Multicast VLAN : 1
MVR Current Learned Groups : 10
MVR Upstream Source IP : 192.168.0.3
.
.
.
Table 122: show mvr - display description
Field Description
MVR Proxy Switching Shows if MVR proxy switching is enabled
MVR Robustness Value Shows the number of reports or query messages sent when proxy
switching is enabled
MVR Proxy Query Interval The interval at which the receiver port sends out general queries
MVR Source Port Mode Shows if the switch only forwards multicast streams which the source
port has dynamcially joined or always forwards multicast streams
MVR Domain An independent multicast domain.
MVR Config Status Shows if MVR is globally enabled on the switch.
MVR Running Status Indicates whether or not all necessary conditions in the MVR
environment are satisfied. (Running status is true as long as MVR Status
is enabled, and the specified MVR VLAN exists.)
MVR Multicast VLAN Shows the VLAN used to transport all MVR multicast traffic.
To Next Page
Loading...
Need help?
General
