EasyManuals Logo

Edge-Core ECS4210-12P User Manual

Edge-Core ECS4210-12P
712 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
Chapter 4
| System Management Commands
File Management
– 105
copy This command moves (upload/download) a code image or configuration file
between the switchs flash memory and an FTP/TFTP server. When you save the
system code or configuration settings to a file on an FTP/TFTP server, that file can
later be downloaded to the switch to restore system operation. The success of the
file transfer depends on the accessibility of the FTP/TFTP server and the quality of
the network connection.
Syntax
copy file {file | ftp | running-config | startup-config | tftp}
copy running-config {file | ftp | startup-config | tftp}
copy startup-config {file | ftp | running-config | tftp}
copy tftp {file | https-certificate | public-key |
running-config | startup-config}
file - Keyword that allows you to copy to/from a file.
ftp - Keyword that allows you to copy to/from an FTP server.
https-certificate - Keyword that allows you to copy the HTTPS secure site
certificate.
public-key - Keyword that allows you to copy a SSH key from a TFTP server.
(See “Secure Shell” on page 209.)
running-config - Keyword that allows you to copy to/from the current
running configuration.
startup-config - The configuration used for system initialization.
tftp - Keyword that allows you to copy to/from a TFTP server.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
The system prompts for data required to complete the copy command.
The destination file name should not contain slashes (\ or /), and the maximum
length for file names is 32 characters for files on the switch or 128 characters for
files on the server. (Valid characters: A-Z, a-z, 0-9, “., “-”)
The switch supports only two operation code files, but the maximum number
of user-defined configuration files is 16.
You can use “Factory_Default_Config.cfg” as the source to copy from the
factory default configuration file, but you cannot use it as the destination.
To replace the startup configuration, you must use startup-config as the
destination.

Table of Contents

Other manuals for Edge-Core ECS4210-12P

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS4210-12P and is the answer not in the manual?

Edge-Core ECS4210-12P Specifications

General IconGeneral
BrandEdge-Core
ModelECS4210-12P
CategoryNetwork Router
LanguageEnglish

Related product manuals