Chapter 4
| System Management Commands
Line
– 120 –
Command Mode
Line Configuration
Example
To set the silent time to 60 seconds, enter this command:
Console(config-line)#silent-time 60
Console(config-line)#
Related Commands
password-thresh (119)
speed This command sets the terminal line’s baud rate. This command sets both the
transmit (to terminal) and receive (from terminal) speeds. Use the no form to
restore the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 19200, 38400, 57600, 115200 bps)
Default Setting
115200 bps
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected to the serial port.
Some baud rates available on devices connected to the port might not be
supported. The system indicates if the speed you selected is not supported.
Example
To specify 57600 bps, enter this command:
Console(config-line)#speed 57600
Console(config-line)#
To Next Page
Loading...
Need help?
General
