Edge-Core ECS4210-12P - Ipv6 Access-Group

Chapter 9 | Access Control Lists
IPv6 ACLs
– 329 –
ipv6 access-group This command binds all ports to an IPv6 ACL. Use the no form to remove the
binding.
Syntax
ipv6 access-group acl-name in
[time-range time-range-name] [counter]
no ipv6 access-group acl-name in
acl-name – Name of the ACL. (Maximum length: 16 characters)
in – Indicates that this list applies to ingress packets.
time-range-name - Name of the time range. (Range: 1-16 characters)
counter – Enables counter for ACL statistics.
Default Setting
None
Command Mode
Global Configuration
Command Usage
If all ports are already bound to an IPv6 ACL and you bind it to a different ACL, the
switch will replace the old binding with the new one.
Example
Console(config)#ipv6 access-group standard david in
Console(config)#
Related Commands
show ipv6 access-group (333)
Time Range (141)
permit, deny
(Standard IPv6 ACL)
This command adds a rule to a Standard IPv6 ACL. The rule sets a filter condition for
packets emanating from the specified source. Use the no form to remove a rule.
Syntax
{permit | deny} {any | host source-ipv6-address |
source-ipv6-address[/prefix-length]}
[time-range time-range-name]
no {permit | deny} {any | host source-ipv6-address |
source-ipv6-address[/prefix-length]}
any – Any source IP address.
host – Keyword followed by a specific IP address.