Chapter 5
| SNMP Commands
Notification Log Commands
– 168 –
Command Usage
â—† Notification logging is enabled by default, but will not start recording
information until a logging profile specified by the snmp-server notify-filter
command is enabled by the nlm command.
â—† Disabling logging with this command does not delete the entries stored in the
notification log.
Example
This example enables the notification log A1.
Console(config)#nlm A1
Console(config)#
snmp-server
notify-filter
This command creates an SNMP notification log. Use the no form to remove this
log.
Syntax
[no] snmp-server notify-filter profile-name remote ip-address
profile-name - Notification log profile name. (Range: 1-32 characters)
ip-address - The Internet address of a remote device. The specified target
host must already have been configured using the snmp-server host
command.
Note:
The notification log is stored locally. It is not sent to a remote device. This
remote host parameter is only required to complete mandatory fields in the SNMP
Notification MIB.
Default Setting
None
Command Mode
Global Configuration
Command Usage
â—† Systems that support SNMP often need a mechanism for recording Notification
information as a hedge against lost notifications, whether those are Traps or
Informs that exceed retransmission limits. The Notification Log MIB (NLM, RFC
3014) provides an infrastructure in which information from other MIBs may be
logged.
â—† Given the service provided by the NLM, individual MIBs can now bear less
responsibility to record transient information associated with an event against
the possibility that the Notification message is lost, and applications can poll
the log to verify that they have not missed any important Notifications.
To Next Page
Loading...
Need help?
General
