Edge-Core ECS4210-12P - Network-Access Dynamic-Qos; Table 51: Dynamic Qos Profiles

Chapter 8 | General Security Measures
Network Access (MAC Address Authentication)
– 253 –
network-access
dynamic-qos
Use this command to enable the dynamic QoS feature for an authenticated port.
Use the no form to restore the default.
Syntax
[no] network-access dynamic-qos
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
◆ The RADIUS server may optionally return dynamic QoS assignments to be
applied to a switch port for an authenticated user. The “Filter-ID” attribute
(attribute 11) can be configured on the RADIUS server to pass the following
QoS information:
◆ When the last user logs off of a port with a dynamic QoS assignment, the switch
restores the original QoS configuration for the port.
◆ When a user attempts to log into the network with a returned dynamic QoS
profile that is different from users already logged on to the same port, the user
is denied access.
◆ While a port has an assigned dynamic QoS profile, any manual QoS
configuration changes only take effect after all users have logged off of the
port.
Note: Any configuration changes for dynamic QoS are not saved to the switch
configuration file.
Table 51: Dynamic QoS Profiles
Profile Attribute Syntax Example
DiffServ service-policy-in=policy-map-name service-policy-in=p1
Rate Limit rate-limit-input=rate rate-limit-input=100 (Kbps)
802.1p switchport-priority-default=value switchport-priority-default=2
IP ACL ip-access-group-in=ip-acl-name ip-access-group-in=ipv4acl
IPv6 ACL ipv6-access-group-in=ipv6-acl-name ipv6-access-group-in=ipv6acl
MAC ACL mac-access-group-in=mac-acl-name mac-access-group-in=macAcl