Chapter 22
| Multicast Filtering Commands
Multicast VLAN Registration
– 587 –
Command Mode
Global Configuration
Example
Console(config)#mvr domain 1 upstream-source-ip 192.168.0.3
Console(config)#
mvr vlan This command specifies the VLAN through which MVR multicast data is received.
Use the no form of this command to restore the default MVR VLAN.
Syntax
mvr domain domain-id vlan vlan-id
no mvr domain domain-id vlan
domain-id - An independent multicast domain. (Range: 1-5)
vlan-id - Specifies the VLAN through which MVR multicast data is received.
This is also the VLAN to which all source ports must be assigned.
(Range: 1-4094)
Default Setting
VLAN 1
Command Mode
Global Configuration
Command Usage
â—† This command specifies the VLAN through which MVR multicast data is
received. This is the VLAN to which all source ports must be assigned.
â—† The VLAN specified by this command must be an existing VLAN configured
with the vlan command.
â—† MVR source ports can be configured as members of the MVR VLAN using the
switchport allowed vlan command and switchport native vlan command, but
MVR receiver ports should not be statically configured as members of this
VLAN.
Example
The following example sets the MVR VLAN to VLAN 2:
Console(config)#mvr
Console(config)#mvr domain 1 vlan 2
Console(config)#
To Next Page
Loading...
Need help?
General
