Chapter 10
| Interface Commands
Interface Configuration
– 357 –
show interfaces status This command displays the status for an interface.
Syntax
show interfaces status [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
port-channel channel-id (Range: 1-8/12)
vlan vlan-id (Range: 1-4094)
Default Setting
Shows the status for all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
64 Octets The total number of packets (including bad packets) received and
transmitted that were less than 64 octets in length (excluding framing
bits but including FCS octets).
65-127 Octets
128-255 Octets
256-511 Octets
512-1023 Octets
1024-1518 Octets
1519-1536 Octets
The total number of packets (including bad packets) received and
transmitted where the number of octets fall within the specified range
(excluding framing bits but including FCS octets).
Utilization Statistics
Octets input per second Number of octets entering this interface in kbits per second.
Packets input per second Number of packets entering this interface in packets per second.
Input utilization The input utilization rate for this interface.
Octets output per second Number of octets leaving this interface in kbits per second.
Packets output per second Number of packets leaving this interface in packets per second.
Output utilization The output utilization rate for this interface.
Table 68: show interfaces counters - display description (Continued)
Parameter Description
To Next Page
Loading...
Need help?
General
