Chapter 22
| Multicast Filtering Commands
MLD Snooping
– 573 –
Example
Console(config)#ipv6 mld snooping query-max-response-time seconds 15
Console(config)#
ipv6 mld snooping
robustness
This command configures the MLD Snooping robustness variable. Use the no form
to restore the default value.
Syntax
ipv6 mld snooping robustness value
no ipv6 mld snooping robustness
value - The number of the robustness variable. (Range: 2-10)
Default Setting
2
Command Mode
Global Configuration
Command Usage
A port will be removed from the receiver list for a multicast service when no MLD
reports are detected in response to a number of MLD queries. The robustness
variable sets the number of queries on ports for which there is no report.
Example
Console(config)#ipv6 mld snooping robustness 2
Console(config)#
ipv6 mld snooping
router-port-
expire-time
This command configures the MLD query timeout. Use the no form to restore the
default.
Syntax
ipv6 mld snooping router-port-expire-time time
no ipv6 mld snooping router-port-expire-time
time - Specifies the timeout of a dynamically learned router port.
(Range: 300-500 seconds)
Default Setting
300 seconds
Command Mode
Global Configuration
To Next Page
Loading...
Need help?
General
