Chapter 4
| System Management Commands
Line
– 113 –
show upgrade This command shows the opcode upgrade configuration settings.
Command Mode
Privileged Exec
Example
Console#show upgrade
Auto Image Upgrade Global Settings:
Status : Disabled
Reload Status : Disabled
Path :
File Name : ECS4210-Series.bix
Console#
Line
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Table 17: Line Commands
Command Function Mode
line Identifies a specific line for configuration and starts the line
configuration mode
GC
accounting exec Applies an accounting method to local console, Telnet or
SSH connections
LC
authorization exec Applies an authorization method to local console, Telnet or
SSH connections
LC
databits
*
Sets the number of data bits per character that are
interpreted and generated by hardware
LC
exec-timeout Sets the interval that the command interpreter waits until
user input is detected
LC
login Enables password checking at login LC
parity
*
Defines the generation of a parity bit LC
password Specifies a password on a line LC
password-thresh Sets the password intrusion threshold, which limits the
number of failed logon attempts
LC
silent-time
*
Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon
attempts exceeds the threshold set by the password-
thresh command
LC
speed
*
Sets the terminal baud rate LC
stopbits
*
Sets the number of the stop bits transmitted per byte LC
timeout login response Sets the interval that the system waits for a login attempt LC
disconnect Terminates a line connection PE
To Next Page
Loading...
Need help?
General
