Chapter 5
| SNMP Commands
SNMPv3 Commands
– 164 –
Examples
This view includes MIB-2.
Console(config)#snmp-server view mib-2 1.3.6.1.2.1 included
Console(config)#
This view includes the MIB-2 interfaces table, ifDescr. The wild card is used to select
all the index values in this table.
Console(config)#snmp-server view ifEntry.2 1.3.6.1.2.1.2.2.1.*.2 included
Console(config)#
This view includes the MIB-2 interfaces table, and the mask selects all index entries.
Console(config)#snmp-server view ifEntry.a 1.3.6.1.2.1.2.2.1.1.* included
Console(config)#
show snmp engine-id This command shows the SNMP engine ID.
Command Mode
Privileged Exec
Example
This example shows the default engine ID.
Console#show snmp engine-id
Local SNMP EngineID: 8000002a8000000000e8666672
Local SNMP EngineBoots: 1
Remote SNMP EngineID IP address
80000000030004e2b316c54321 192.168.1.19
Console#
Table 26: show snmp engine-id - display description
Field Description
Local SNMP engineID String identifying the engine ID.
Local SNMP engineBoots The number of times that the engine has (re-)initialized since the snmp
EngineID was last configured.
Remote SNMP engineID String identifying an engine ID on a remote device.
IP address IP address of the device containing the corresponding remote SNMP
engine.
To Next Page
Loading...
Need help?
General
