Edge-Core ECS4210-12P User Manual

Chapter 4 | System Management Commands
Event Logging
– 127 –
◆ The maximum number of host IP addresses allowed is five.
Example
Console(config)#logging host 10.1.0.3
Console(config)#
logging on This command controls logging of error messages, sending debug or error
messages to a logging process. The no form disables the logging process.
Syntax
[no] logging on
Default Setting
None
Command Mode
Global Configuration
Command Usage
The logging process controls error messages saved to switch memory or sent to
remote syslog servers. You can use the logging history command to control the
type of error messages that are stored in memory. You can use the logging trap
command to control the type of error messages that are sent to specified syslog
servers.
Example
Console(config)#logging on
Console(config)#
Related Commands
logging history (125)
logging trap (128)
clear log (128)

Edge-Core ECS4210-12P Specifications

General

Brand	Edge-Core
Model	ECS4210-12P
Category	Network Router
Language	English

Summary

Section I Getting Started

Initial Switch Configuration

Information on connecting to the switch and basic configuration procedures.

Section II Command Line Interface

Using the Command Line Interface

Explains how to access and use the CLI, including console and Telnet connections.

Entering Commands

Details on entering CLI commands, including keywords, arguments, completion, and history.

CLI Command Groups

Categorizes system commands into functional groups like General, System Management, and SNMP.

Section III Appendices

Troubleshooting

Provides actions for common problems when accessing the management interface via Telnet, web browser, or serial connection.

Glossary

Defines key networking terms and acronyms used throughout the manual.