Chapter 17
| Address Table Commands
– 434 –
show mac-address-
table max-mac-count
This command shows the maximum number of MAC addresses which can be
learned on an interface.
Syntax
show mac-address-table max-mac-count [interface interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
Default Setting
None
Command Mode
Privileged Exec
Example
Console#show mac-address-table max-mac-count
Interface Max Count Current Count MAC learning limit Action
--------- --------- ------------- -------------------------
Eth 1/ 1 0 0 None
Eth 1/ 2 0 2 None
Eth 1/ 3 24 0 None
Eth 1/ 4 0 0 None
Eth 1/ 5 0 0 None
.
.
.
show mac-address-
table movable-static
This command shows the movable-static configuration settings.
Syntax
show mac-address-table movable-static [[interface interface] |
[vlan vlan-id]]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
port-channel channel-id (Range: 1-8/12)
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
None
To Next Page
Loading...
Need help?
General
