Edge-Core ECS4210-12P - Auto-Traffic-Control Control-Release

Chapter 14 | Congestion Control Commands
Automatic Traffic Control Commands
– 405 –
auto-traffic-control
control-release
This command manually releases a control response.
Syntax
auto-traffic-control {broadcast | multicast} control-release
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
Command Mode
Interface Configuration (Ethernet)
Command Usage
This command can be used to manually stop a control response of rate-limiting or
port shutdown any time after the specified action has been triggered.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#auto-traffic-control broadcast control-release
Console#(config-if)
SNMP Trap Commands
snmp-server
enable port-traps atc
broadcast-alarm-clear
This command sends a trap when broadcast traffic falls beneath the lower
threshold after a storm control response has been triggered. Use the no form to
disable this trap.
Syntax
[no] snmp-server enable port-traps atc broadcast-alarm-clear
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc broadcast-alarm-clear
Console(config-if)#
Related Commands
auto-traffic-control action (401)
auto-traffic-control alarm-clear-threshold (402)