Chapter 19
| VLAN Commands
GVRP and Bridge Extension Commands
– 470 –
show garp timer This command shows the GARP timers for the selected interface.
Syntax
show garp timer [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
port-channel channel-id (Range: 1-8/12)
Default Setting
Shows all GARP timers.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show garp timer ethernet 1/1
Eth 1/ 1 GARP timer status:
Join Timer: 20 centiseconds
Leave Timer: 60 centiseconds
Leaveall Timer: 1000 centiseconds
Console#
Related Commands
garp timer (467)
Traffic Classes This switch provides mapping of user priorities to multiple traffic classes. (Refer
to “Class of Service Commands” on page 505.)
Global GVRP Status GARP VLAN Registration Protocol defines a way for switches to exchange VLAN
information in order to automatically register VLAN members on interfaces
across the network. This field shows if GVRP is globally enabled or disabled.
(Refer to the bridge-ext gvrp command.)
Table 95: show bridge-ext - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General
