Edge-Core ECS4210-12P - Loopback-Detection Transmit-Interval

Chapter 16 | Loopback Detection Commands
– 420 –
Example
Console(config)#loopback-detection recover-time 120
Console(config-if)#
loopback-detection
transmit-interval
This command specifies the interval at which to transmit loopback detection
control frames. Use the no form to restore the default setting.
Syntax
loopback-detection transmit-interval seconds
[no] loopback-detection transmit-interval
seconds - The transmission interval for loopback detection control frames.
(Range: 1-32767 seconds)
Default Setting
10 seconds
Command Mode
Global Configuration
Example
Console(config)#loopback-detection transmit-interval 60
Console(config)#
loopback-detection
release
This command releases all interfaces currently shut down by the loopback
detection feature.
Syntax
loopback-detection release
Command Mode
Privileged Exec
Example
Console#loopback-detection release
Console(config)#