Edge-Core ECS4210-12P - Ip Access-Group

Chapter 9 | Access Control Lists
IPv4 ACLs
– 321 –
ip access-group This command binds an IPv4 ACL to all ports. Use the no form to remove the
binding.
Syntax
ip access-group acl-name in [time-range time-range-name] [counter]
no ip access-group acl-name in
acl-name – Name of the ACL. (Maximum length: 16 characters)
in – Indicates that this list applies to ingress packets.
time-range-name - Name of the time range. (Range: 1-16 characters)
counter – Enables counter for ACL statistics.
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆ Only one IPv4 ACL can be bound to a port.
◆ If an IPv4 ACL is already bound to the switch and you bind a different IPv4 ACL
to it, the switch will replace the old binding with the new one.
Example
Console(config)#ip access-group david in
Console(config)#
Related Commands
show ip access-group (326)
Time Range (141)