Edge-Core ECS4210-12P - Mvr Domain

Chapter 22 | Multicast Filtering Commands
Multicast VLAN Registration
– 582 –
Related Commands
mvr profile (582)
mvr domain This command enables Multicast VLAN Registration (MVR) for a specific domain.
Use the no form of this command to disable MVR for a domain.
Syntax
[no] mvr domain domain-id
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
Only IGMP version 2 or 3 hosts can issue multicast join or leave messages. If MVR
must be configured for an IGMP version 1 host, the multicast groups must be
statically assigned using the mvr vlan group command.
Example
The following example enables MVR for domain 1:
Console(config)#mvr domain 1
Console(config)#
mvr profile This command maps a range of MVR group addresses to a profile. Use the no form
of this command to remove the profile.
Syntax
mvr profile profile-name start-ip-address end-ip-address
profile-name - The name of a profile containing one or more MVR group
addresses. (Range: 1-21 characters)
start-ip-address - Starting IPv4 address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
end-ip-address - Ending IPv4 address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
Default Setting
No profiles are defined