Edge-Core ECS4210-12P - Traffic-Segmentation Uplink;Downlink

Chapter 8 | General Security Measures
Port-based Traffic Segmentation
– 315 –
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
Command Usage
◆ Use this command to create a new traffic-segmentation client session.
◆ Using the no form of this command will remove any assigned uplink or
downlink ports, restoring these interfaces to normal operating mode.
Example
Console(config)#traffic-segmentation session 1
Console(config)#
traffic-segmentation
uplink/downlink
This command configures the uplink and down-link ports for a segmented
group of ports. Use the no form to remove a port from the segmented
group.
SYNTAX
[no] traffic-segmentation [session session-id] {uplink interface-list
[downlink interface-list] | downlink interface-list}
session-id – Traffic segmentation session. (Range: 1-4)
uplink – Specifies an uplink interface.
downlink – Specifies a downlink interface.
interface-list – One or more ports. Use a hyphen to indicate a
consecutive list of ports or a comma between non-consecutive
ports.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
DEFAULT SETTING
Session 1 if not defined
No segmented port groups are defined.
COMMAND MODE
Global Configuration
COMMAND USAGE
◆ A port cannot be configured in both an uplink and downlink list.