Edge-Core ECS4210-12P - Table 45: Pppoe Intermediate Agent Commands

Chapter 7 | Authentication Commands
PPPoE Intermediate Agent
– 236 –
2. 192.168.1.25 192.168.1.30
SNMP-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
TELNET-Client:
Start IP address End IP address
-----------------------------------------------
1. 192.168.1.19 192.168.1.19
2. 192.168.1.25 192.168.1.30
Console#
PPPoE Intermediate Agent
This section describes commands used to configure the PPPoE Intermediate Agent
(PPPoE IA) relay parameters required for passing authentication messages between
a client and broadband remote access servers.
Table 45: PPPoE Intermediate Agent Commands
Command Function Mode
pppoe intermediate-agent Enables the PPPoE IA globally on the switch GC
pppoe intermediate-agent
format-type
Sets the access node identifier and generic error message
for the switch
GC
pppoe intermediate-agent
port-enable
Enables the PPPoE IA on an interface IC
pppoe intermediate-agent
port-format-type
Sets the circuit-id or remote-id for an interface IC
pppoe intermediate-agent
trust
Sets the trust mode for an interface IC
pppoe intermediate-agent
vendor-tag strip
Enables the stripping of vendor tags from PPPoE Discovery
packets sent from a PPPoE server
IC
clear pppoe intermediate-
agent statistics
Clears PPPoE IA statistics PE
show pppoe intermediate-
agent info
Displays PPPoE IA configuration settings PE
show pppoe intermediate-
agent statistics
Displays PPPoE IA statistics PE