Edge-Core ECS4210-12P - Show Ip Source-Guard; Show Ip Source-Guard Binding

Chapter 8 | General Security Measures
IP Source Guard
– 284 –
discovered by DHCP snooping and static entries set by the ip source-guard
command.
Example
This example sets the maximum number of allowed entries in the binding table for
port 5 to one entry.
Console(config)#interface ethernet 1/5
Console(config-if)#ip source-guard max-binding 1
Console(config-if)#
show ip source-guard This command shows whether source guard is enabled or disabled on each
interface.
Command Mode
Privileged Exec
Example
Console#show ip source-guard
Interface Filter-type Max-binding
--------- ----------- -----------
Eth 1/1 DISABLED 5
Eth 1/2 DISABLED 5
Eth 1/3 DISABLED 5
Eth 1/4 DISABLED 5
Eth 1/5 SIP 1
Eth 1/6 DISABLED 5
.
.
.
show ip source-guard
binding
This command shows the source guard binding table.
Syntax
show ip source-guard binding [dhcp-snooping | static]
dhcp-snooping - Shows dynamic entries configured with DHCP Snooping
commands (see page 269)
static - Shows static entries configured with the ip source-guard binding
command.
Command Mode
Privileged Exec