Edge-Core ECS4210-12P - Snmp-Server Enable Port-Traps Atc Multicast-Control-Release

Chapter 14 | Congestion Control Commands
Automatic Traffic Control Commands
– 409 –
snmp-server
enable port-traps atc
multicast-control-
release
This command sends a trap when multicast traffic falls beneath the lower threshold
after a storm control response has been triggered and the release timer expires.
Use the no form to disable this trap.
Syntax
[no] snmp-server enable port-traps atc multicast-control-release
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#snmp-server enable port-traps atc multicast-control-
release
Console(config-if)#
Related Commands
auto-traffic-control alarm-clear-threshold (402)
auto-traffic-control action (401)
auto-traffic-control release-timer (400)
ATC Display Commands
show auto-traffic-
control
This command shows global configuration settings for automatic storm control.
Command Mode
Privileged Exec
Example
Console#show auto-traffic-control
Storm-control: Broadcast
Apply-timer (sec) : 300
release-timer (sec) : 900
Storm-control: Multicast
Apply-timer(sec) : 300
release-timer(sec) : 900
Console#