Chapter 17
| Address Table Commands
– 428 –
Example
Console(config)#mac-address-table static 00-01-02-03-04-05 interface ethernet
1/1 vlan 1
Console(config)#mac-address-table movable-static interface ethernet 1/1
Console(config)#
mac-address-table
static
This command maps a static address to a port in a VLAN, and optionally designates
the address as permanent, to be deleted on reset, or movable-static. Use the no
form to remove an address.
Syntax
mac-address-table static mac-address interface interface vlan vlan-id
[delete-on-reset | permanent | movable-static]
no mac-address-table static mac-address vlan vlan-id
mac-address - MAC address.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
port-channel channel-id (Range: 1-8/12)
vlan-id - VLAN ID (Range: 1-4094)
delete-on-reset - Assignment lasts until the switch is reset.
permanent - Assignment is permanent.
movable-static - Specifies an interface to which a static MAC address can
be moved. See mac-address-table movable-static.
Default Setting
No static addresses are defined.
The default lifetime is permanent.
Command Mode
Global Configuration
Command Usage
The static address for a host device can be assigned to a specific port within a
specific VLAN. Use this command to add static addresses to the MAC Address Table.
Static addresses have the following characteristics:
◆ Static addresses will not be removed from the address table when a given
interface link is down.
To Next Page
Loading...
