– 645 –
26 IP Interface Commands
An IP Version 4 and Version 6 address may be used for management access to the
switch over the network. Both IPv4 or IPv6 addresses can be used simultaneously to
access the switch. You can manually configure a specific IPv4 or IPv6 address or
direct the switch to obtain an IPv4 address using Auto IP, or from a BOOTP or DHCP
server when it is powered on. An IPv6 address can either be manually configured or
dynamically generated.
An IPv4 address for this switch is obtained via DHCP by default for VLAN 1. You may
also need to a establish an IPv4 or IPv6 default gateway between this device and
management stations that exist on another network segment.
IPv4 Interface
An IP address is assigned to this switch using Auto IP by default. If this address is
not compatible with your network, you must manually configure a new address to
manage the switch over your network or to connect the switch to existing IP
subnets. You may also need to a establish a default gateway between this device
and management stations or other devices that exist on another network segment
This section includes commands for configuring IP interfaces, the Address
Resolution Protocol (ARP) and Proxy ARP.
Table 136: IP Interface Commands
Command Group Function
IPv4 Interface Configures an IPv4 address for the switch
IPv6 Interface Configures an IPv6 address for the switch
Table 137: IPv4 Interface Commands
Command Group Function
Basic IPv4 Configuration Configures the IP address for interfaces and the gateway router
ARP Configuration Configures static, dynamic and proxy ARP service
To Next Page
Loading...
Need help?
General
