Edge-Core ECS4210-12P - Show Qos Map Cos-Dscp

Chapter 20 | Class of Service Commands
Priority Commands (Layer 3 and 4)
– 515 –
show qos map
cos-dscp
This command shows ingress CoS/CFI to internal DSCP map.
Syntax
show qos map cos-dscp interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
port-channel channel-id (Range: 1-8/12)
Command Mode
Privileged Exec
Example
Console#show qos map cos-dscp interface ethernet 1/5
CoS Information of Eth 1/5
CoS-DSCP Map. (x,y),x: PHB,y: drop precedence:
CoS : CFI 0 1
---------------------------------
0 (0,0) (0,0)
1 (1,0) (1,0)
2 (2,0) (2,0)
3 (3,0) (3,0)
4 (4,0) (4,0)
5 (5,0) (5,0)
6 (6,0) (6,0)
7 (7,0) (7,0)
Console#
show qos map
dscp-mutation
This command shows the ingress DSCP to internal DSCP map.
Syntax
show qos map dscp-mutation interface interface
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12/28)
port-channel channel-id (Range: 1-8/12)
Command Mode
Privileged Exec
Command Usage
This map is only used when the QoS mapping mode is set to “DSCP” by the qos
map trust-mode command, and the ingress packet type is IPv4.