Chapter 22
| Multicast Filtering Commands
Multicast VLAN Registration
– 585 –
Example
The following example enable MVR proxy switching.
Console(config)#mvr proxy-switching
Console(config)#
Related Commands
mvr robustness-value (585)
mvr robustness-value This command configures the expected packet loss, and thereby the number of
times to generate report and group-specific queries. Use the no form to restore the
default setting.
Syntax
mvr robustness-value value
no mvr robustness-value
value - The robustness used for all interfaces. (Range: 1-255)
Default Setting
2
Command Mode
Global Configuration
Command Usage
â—† This command is used to set the number of times report messages are sent
upstream when changes are learned about downstream groups, and the
number of times group-specific queries are sent to downstream receiver ports.
â—† This command only takes effect when MVR proxy switching is enabled.
Example
Console(config)#mvr robustness-value 5
Console(config)#
Related Commands
mvr proxy-switching (584)
To Next Page
Loading...
Need help?
General
