Chapter 23
| LLDP Commands
– 612 –
Command Usage
This option advertises Power-over-Ethernet capabilities, including whether or not
PoE is supported, currently enabled, if the port pins through which power is
delivered can be controlled, the port pins selected to deliver power, and the power
class.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp dot3-tlv poe
Console(config-if)#
lldp med-location
civic-addr
This command configures an LLDP-MED-enabled port to advertise its location
identification details. Use the no form to restore the default settings.
Syntax
lldp med-location civic-addr [[country country-code] | [what device-type] |
[ca-type ca-value]]
no lldp med-location civic-addr [[country] | [what] | [ca-type]]
country-code – The two-letter ISO 3166 country code in capital ASCII letters.
(Example: DK, DE or US)
device-type – The type of device to which the location applies.
0 – Location of DHCP server.
1 – Location of network element closest to client.
2 – Location of client.
ca-type – A one-octet descriptor of the data civic address value.
(Range: 0-255)
ca-value – Description of a location. (Range: 1-32 characters)
Default Setting
Not advertised
No description
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
â—† Use this command without any keywords to advertise location identification
details.
â—† Use the ca-type to advertise the physical location of the device, that is the city,
street number, building and room information. The address location is
specified as a type and value pair, with the civic address (CA) type being
To Next Page
Loading...
Need help?
General
