Chapter 9
| Access Control Lists
ACL Information
– 342 –
Related Commands
permit, deny (340)
ACL Information
This section describes commands used to display ACL information.
clear access-list
hardware counters
This command clears the hit counter for the rules in all ACLs, or for the rules in a
specified ACL.
Syntax
clear access-list hardware counters [acl-name]
acl-name – Name of the ACL. (Maximum length: 32 characters)
Command Mode
Privileged Exec
Example
Console#clear access-list hardware counters
Console#
show access-group This command shows the port assignments of ACLs.
Command Mode
Privileged Executive
Example
Console#show access-group
Interface ethernet 1/2
IP access-list david
MAC access-list jerry
Global
IP access-list david in
IPv6 access-list jerry in counter
Console#
Table 66: ACL Information Commands
Command Function Mode
clear access-list hardware
counters
Clears hit counter for rules in all ACLs, or in a specified ACL. PE
show access-group Shows the ACLs assigned to each port PE
show access-list Show all ACLs and associated rules PE
To Next Page
Loading...
Need help?
General
