Chapter 5
| SNMP Commands
SNMPv3 Commands
– 161 –
Command Usage
◆ A group sets the access policy for the assigned users.
◆ When authentication is selected, the MD5 or SHA algorithm is used as specified
in the snmp-server user command.
◆ When privacy is selected, the DES 56-bit algorithm is used for data encryption.
◆ For additional information on the notification messages supported by this
switch, see the table for "Supported Notification Messages" in the Web
Management Guide. Also, note that the authentication, link-up and link-down
messages are legacy traps and must therefore be enabled in conjunction with
the snmp-server enable traps command.
Example
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
To Next Page
Loading...
