Chapter 2
| Using the Command Line Interface
Entering Commands
– 67 –
public-key Public key information
qos Quality of Service
queue Priority queue information
radius-server RADIUS server information
reload Shows the reload settings
rmon Remote Monitoring Protocol
rspan Display status of the current RSPAN configuration
running-config Information on the running configuration
snmp Simple Network Management Protocol configuration and
statistics
sntp Simple Network Time Protocol configuration
spanning-tree Spanning-tree configuration
ssh Secure shell server connections
startup-config Startup system configuration
subnet-vlan IP subnet-based VLAN information
system System information
tacacs-server TACACS server information
tech-support Technical information
time-range Time range
traffic-segmentation Traffic segmentation information
udld Displays UDLD information
upgrade Shows upgrade information
users Information about users logged in
version System hardware and software versions
vlan Shows virtual LAN settings
vlan-translation VLAN translation information
voice Shows the voice VLAN information
watchdog Displays watchdog status
web-auth Shows web authentication configuration
Console#show
The command “show interfaces ?” will display the following information:
Console#show interfaces ?
brief Shows brief interface description
counters Interface counters information
protocol-vlan Protocol-VLAN information
status Shows interface status
switchport Shows interface switchport information
transceiver Interface of transceiver information
Console#
Show commands which display more than one page of information (e.g., show
running-config) pause and require you to press the [Space] bar to continue
displaying one more page, the [Enter] key to display one more line, or the [a] key to
display the rest of the information without stopping. You can press any other key to
terminate the display.
To Next Page
Loading...
Need help?
General
