Edge-Core ES4524M-POE

System Management Commands
4-29
4
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
Example
Related Commands
dir (4-27)
whichboot (4-28)
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
* These commands only apply to the serial port.
Console(config)#boot system config: startup
Console(config)#
Table 4-12 Line Command Syntax
Command Function Mode Page
line Identifies a specific line for configuration and starts the line
configuration mode
GC 4-30
login Enables password checking at login LC 4-30
password Specifies a password on a line LC 4-31
timeout login
response
Sets the interval that the system waits for a login attempt LC 4-32
exec-timeout Sets the interval that the command interpreter waits until user
input is detected
LC 4-33
password-thresh Sets the password intrusion threshold, which limits the number of
failed logon attempts
LC 4-33
silent-time* Sets the amount of time the management console is inaccessible
after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command
LC 4-34
databits* Sets the number of data bits per character that are interpreted and
generated by hardware
LC 4-35
parity* Defines the generation of a parity bit LC 4-35
speed* Sets the terminal baud rate LC 4-36
stopbits* Sets the number of the stop bits transmitted per byte LC 4-37
disconnect Terminates a line connection PE 4-37
show line Displays a terminal line's parameters NE, PE 4-38