VLAN Commands
4-207
4
switchport private-vlan mapping
Use this command to map an interface to a primary VLAN. Use the no form to
remove this mapping.
Syntax
switchport private-vlan mapping primary-vlan-id
no switchport private-vlan mapping
primary-vlan-id - ID of primary VLAN. (Range: 1-4093, no leading zeroes).
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
Promiscuous ports assigned to a primary VLAN can communicate with any
other promiscuous ports in the same VLAN, and with the group members
within any associated secondary VLANs.
Example
show vlan private-vlan
Use this command to show the private VLAN configuration settings on this switch.
Syntax
show vlan private-vlan mapping [community | primary]
• community – Displays all community VLANs, along with their associated
primary VLAN and assigned host interfaces.
• primary – Displays all primary VLANs, along with any assigned
promiscuous interfaces.
Default Setting
None
Command Mode
Privileged Executive
Console(config)#interface ethernet 1/2
Console(config-if)#switchport private-vlan mapping 2
Console(config-if)#
To Next Page
Loading...
Need help?
General