Command Groups
4-9
4
Command Groups
The system commands can be broken down into the functional groups shown below.
Table 4-4 Command Group Index
Command Group Description Page
General Basic commands for entering privileged access mode, restarting the
system, or quitting the CLI
4-10
System Management Display and setting of system information, basic modes of operation,
maximum frame size, file management, console port and telnet
settings, system logs, SMTP alerts, system clock, switch clustering,
and UPnP
4-15
Simple Network
Management Protocol
Activates authentication failure traps; configures community access
strings, and trap receivers
4-60
User Authentication Configures user names and passwords, logon access using local or
remote authentication, management access through the web server,
Telnet server and Secure Shell; as well as port security, IEEE 802.1X
port access control, and restricted access based on specified IP
addresses
4-75
Client Security Segregates traffic for clients attached to common data ports; and
prevents unauthorized access by configuring valid static or dynamic
addresses, and filtering DHCP requests and replies
4-109
Access Control Lists Provides filtering for IP frames (based on address, protocol, TCP/UDP
port number or TCP control code) or non-IP frames (based on MAC
address or Ethernet type)
4-122
Interface Configures the connection parameters for all Ethernet ports,
aggregated links, and VLANs
4-135
Link Aggregation Statically groups multiple ports into a single logical trunk; configures
Link Aggregation Control Protocol for port trunks
4-147
Mirror Port Mirrors data to another port for analysis without affecting the data
passing through or the performance of the monitored port
4-157
Rate Limit Controls the maximum rate for traffic transmitted or received on a port 4-159
Power over Ethernet Configures power output for connected devices 4-160
Address Table Configures the address table for filtering specified addresses, displays
current entries, clears the table, or sets the aging time
4-166
Spanning Tree Configures Spanning Tree settings for the switch 4-169
VLANs Configures VLAN settings, and defines port membership for VLAN
groups; also enables or configures private VLANs and protocol VLANs
4-189
Link Layer Discovery
Protocol
Configures advertisement and learning of basic information about
neighboring devices
4-212
Class of Service Sets port priority for untagged frames, selects strict priority or weighted
round robin, relative weight for each priority queue, also sets priority for
TCP/UDP traffic types, and DSCP
4-234
Quality of Service Configures Differentiated Services 4-243
Multicast Filtering Configures IGMP multicast filtering, query parameters, specifies ports
attached to a multicast router, and configures multicast VLAN registration
4-252
IP Interface Configures IP address for the switch 4-268
To Next Page
Loading...
