Edge-Core ES4524M-POE

Configuring the Switch
3-58
CLI – Specify all the required parameters to enable logon authentication.
Configuring HTTPS
You can configure the switch to enable the Secure Hypertext Transfer Protocol
(HTTPS) over the Secure Socket Layer (SSL), providing secure access (i.e., an
encrypted connection) to the switch’s web interface.
Command Usage
• Both the HTTP and HTTPS service can be enabled independently on the switch.
However, you cannot configure both services to use the same UDP port.
• If you enable HTTPS, you must indicate this in the URL that you specify in your
browser: https://device[:port_number]
Console(config)#authentication login radius 4-78
Console(config)#radius-server port 181 4-81
Console(config)#radius-server key green 4-81
Console(config)#radius-server retransmit 5 4-82
Console(config)#radius-server timeout 10 4-82
Console(config)#radius-server 1 host 192.168.1.25 4-80
Console(config)#exit
Console#show radius-server 4-82
Remote RADIUS Server Configuration:
Global Settings:
Communication Key with RADIUS Server: *****
Auth-Port: 181
Retransmit Times: 5
Request Timeout: 10
Server 1:
Server IP Address: 192.168.1.25
Communication Key with RADIUS Server: *****
Auth-Port: 181
Retransmit Times: 5
Request Timeout: 10
Console(config)#config
Console(config)#authentication login tacacs 4-78
Console(config)#tacacs-server host 10.20.30.40 4-83
Console(config)#tacacs-server port 200 4-84
Console(config)#tacacs-server key green 4-84
Console(config)#exit
Console#show tacacs-server 4-85
Remote TACACS+ server configuration:
Global Settings:
Remote TACACS Server Configuration:
Server IP Address: 10.20.30.40
Communication Key with TACACS+ Server: *****
Server Port Number: 200
Retransmit Times : 2
Request Times : 5
Console#