Edge-Core ES4524M-POE

Command Line Interface
4-266
4
show mvr interface
This command shows information about the interfaces attached to the MVR VLAN.
Syntax
show mvr interface [interface]
interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-24)
• port-channel channel-id (Range: 1-8)
Default Setting
Displays status for all attached interfaces.
Command Mode
Privileged Exec
Example
The following displays information about the interfaces attached to the MVR VLAN:
Console#show mvr interface
Port Type Status Immediate Leave
------- -------- ------------- ---------------
eth1/1 SOURCE ACTIVE/UP Disable
eth1/2 RECEIVER ACTIVE/UP Disable
eth1/5 RECEIVER INACTIVE/DOWN Disable
eth1/6 RECEIVER INACTIVE/DOWN Disable
eth1/7 RECEIVER INACTIVE/DOWN Disable
Console#
Table 4-1 show mvr interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status
• If a source port has been added to an MVR VLAN (via manual configuration), and
MVR is enabled, its status is “Active.” If a receiver port has been added an MVR
VLAN (via dynamic configuration), and MVR is enabled, its status is “Active.”
• Interface status shows “UP” if there is a valid link.
Immediate Leave Shows if immediate leave is enabled or disabled.