Switch Clustering
3-221
Cluster Member Configuration
Adds Candidate switches to the cluster as Members.
Command Attributes
• Member ID – Specify a Member ID number for the selected Candidate switch.
(Range: 1-36)
• MAC Address – Select a discovered switch MAC address from the Candidate
Table, or enter a specific MAC address of a known switch.
Web – Click Cluster, Member Configuration.
Figure 3-113 Cluster Member Configuration
CLI – This example creates a new cluster Member by specifying the Candidate
switch MAC address and setting a Member ID.
Console(config)#cluster member mac-address 00-12-34-56-78-9a
id 5 4-56
Console(config)#
To Next Page
Loading...
