Command Line Interface
4-58
4
Example
UPnP Commands
Universal Plug and Play (UPnP) is a set of protocols that allows devices to connect
seamlessly and simplifies the deployment of home and office networks. UPnP
achieves this by issuing UPnP device control protocols designed upon open,
Internet-based communication standards.
The commands described in this section allow the switch to advertise itself as a
UPnP compliant device. When discovered by a host device, basic information about
this switch can be displayed, and the web management interface accessed.
upnp device
This command enables UPnP on the device. Use the no form to disable UPnP.
Syntax
[no] upnp device
Default Setting
Enabled
Command Mode
Global Configuration
Example
Console#show cluster candidates
Cluster Candidates:
Role Mac Description
------------- ----------------- --------------------------------
ACTIVE MEMBER 00-12-cf-23-49-c0 SMC8124PL2
CANDIDATE 00-12-cf-0b-47-a0 SMC8124PL2
Console#
Table 4-20 UPnP Commands
Command Function Mode Page
upnp device Enables UPnP on the network GC 4-58
upnp device ttl Sets the time-to-live (TTL) value. GC 4-59
upnp device advertise
duration
Sets the advertisement duration of the device GC 4-59
show upnp Displays UPnP status and parameters PE 4-60
Console(config)#upnp device
Console(config)#
To Next Page
Loading...
Need help?
General