Edge-Core ES4524M-POE

LLDP Commands
4-215
4
Example
lldp medFastStartCount
This command specifies the number of MED Fast Start LLDPDUs to transmit during
the activation process of the LLDP-MED Fast Start mechanism.
Syntax
lldp medfaststartcount packets
seconds - Number of packets. (Range: 1-10 packets; Default: 4 packets)
Default Setting
4 packets
Command Mode
Global Configuration
Command Usage
The MEDFastStartCount parameter is part of the timer which ensures that the
LLDP-MED Fast Start mechanism is active for the port. LLDP-MED Fast Start
is critical to the timely startup of LLDP, and therefore integral to the rapid
availability of Emergency Call Service.
Example
lldp notification-interval
This command configures the allowed interval for sending SNMP notifications about
LLDP MIB changes. Use the no form to restore the default setting.
Syntax
lldp notification-interval seconds
no lldp notification-interval
• seconds - Specifies the periodic interval at which SNMP notifications are sent.
(Range: 5 - 3600 seconds)
Default Setting
5 seconds
Command Mode
Global Configuration
Console(config)#lldp holdtime-multiplier 10
Console(config)#
Console(config)#lldp medfaststartcount 6
Console(config)#