VLAN Commands
4-195
4
vlan
This command configures a VLAN. Use the no form to restore the default settings or
delete a VLAN.
Syntax
vlan vlan-id [name vlan-name] media ethernet [state {active | suspend}]
no vlan vlan-id [name | state]
• vlan-id - ID of configured VLAN. (Range: 1-4093, no leading zeroes)
• name - Keyword to be followed by the VLAN name.
• vlan-name - ASCII string from 1 to 32 characters.
• media ethernet - Ethernet media type.
• state - Keyword to be followed by the VLAN state.
• active - VLAN is operational.
• suspend - VLAN is suspended. Suspended VLANs do not pass packets.
Default Setting
By default only VLAN 1 exists and is active.
Command Mode
VLAN Database Configuration
Command Usage
• no vlan vlan-id deletes the VLAN.
• no vlan vlan-id name removes the VLAN name.
• no vlan vlan-id state returns the VLAN to the default state (i.e., active).
• You can configure up to 255 VLANs on the switch.
• The switch allows 255 user-manageable VLANs. One extra, unmanageable
VLAN (VLAN ID 4093) is maintained for switch clustering.
Example
The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN
is activated by default.
Related Commands
show vlan (4-202)
Console(config)#vlan database
Console(config-vlan)#vlan 105 name RD5 media ethernet
Console(config-vlan)#
To Next Page
Loading...
Need help?
General