Edge-Core ES4524M-POE

Command Line Interface
4-224
4
lldp dot1-tlv pvid
This command configures an LLDP-enabled port to advertise its default VLAN ID.
Use the no form to disable this feature.
Syntax
[no] lldp dot1-tlv pvid
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The port’s default VLAN identifier (PVID) indicates the VLAN with which
untagged or priority-tagged frames are associated (see switchport native
vlan on page 4-199).
Example
lldp dot1-tlv vlan-name
This command configures an LLDP-enabled port to advertise its VLAN name. Use
the no form to disable this feature.
Syntax
[no] lldp dot1-tlv vlan-name
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the name of all VLANs to which this interface has been
assigned. See switchport allowed vlan on page 4-200 and protocol-vlan
protocol-group vlan on page 4-209.
Example
Console(config)#interface eth 1/1
Console(config-if)#lldp dot1-tlv pvid
Console(config-if)#
Console(config)#interface eth 1/1
Console(config-if)#lldp dot1-tlv vlan-name
Console(config-if)#