Edge-Core ES4524M-POE

Configuring the Switch
3-100
Web – Click Port, Port Information or Trunk Information.
Figure 3-54 Port Status Information
Field Attributes (CLI)
Basic Information:
• Port type – Indicates the port type. (1000T or 1000Base SFP)
• MAC address – The physical layer address for this port. (To access this item on
the web, see “Setting the Switch’s IP Address” on page 3-15.)
Configuration:
• Name – Interface label.
• Port Admin – Shows if the interface is enabled or disabled (i.e., up or down).
• Speed-duplex – Shows the current speed and duplex mode. (Auto, or fixed choice)
• Capabilities – Specifies the capabilities to be advertised for a port during
auto-negotiation. (To access this item on the web, see “Configuring Interface
Connections” on page 3-48.) The following capabilities are supported.
- 10half - Supports 10 Mbps half-duplex operation
- 10full - Supports 10 Mbps full-duplex operation
- 100half - Supports 100 Mbps half-duplex operation
- 100full - Supports 100 Mbps full-duplex operation
- 1000full - Supports 1000 Mbps full-duplex operation
- Sym - Transmits and receives pause frames for flow control
- FC - Supports flow control
• Broadcast Storm – Shows if broadcast storm control is enabled or disabled.