LLDP Commands
4-223
4
lldp dot1-tlv proto-ident
This command configures an LLDP-enabled port to advertise the supported
protocols. Use the no form to disable this feature.
Syntax
[no] lldp dot1-tlv proto-ident
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the protocols that are accessible through this interface.
Example
lldp dot1-tlv proto-vid
This command configures an LLDP-enabled port to advertise port-related VLAN
information. Use the no form to disable this feature.
Syntax
[no] lldp dot1-tlv proto-vid
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the port-based and protocol-based VLANs configured
on this interface (see “Configuring VLAN Interfaces” on page 4-196 and
“Configuring Protocol-based VLANs” on page 4-208).
Example
Console(config)#interface eth 1/1
Console(config-if)#lldp dot1-tlv protocol-identity
Console(config-if)#
Console(config)#interface eth 1/1
Console(config-if)#lldp dot1-tlv proto-vid
Console(config-if)#
To Next Page
Loading...
Need help?
General