Edge-Core ES4524M-POE

Command Line Interface
4-164
4
Command Usage
• If the power demand from devices connected to the switch exceeds the power
budget setting, the switch uses port power priority settings to control the
supplied power. For example:
- A device connected to a low-priority port that causes the switch to exceed
its budget is not supplied power.
- A device connected to a critical or high-priority port that causes the switch
to exceed its budget is supplied power, but the switch drops power to one
or more lower-priority ports.
• Power is dropped from low-priority ports in sequence starting from port
number 1.
Example
Related Commands
power mainpower maximum allocation (4-160)
show power inline status
This command displays the current power status for all ports or for specific ports.
Syntax
show power inline status [interface]
interface
ethernet
• unit - Stack unit. (Range: 1)
• port - Port number. (Range: 1-24)
Command Mode
Privileged Exec
Example
Console(config)#interface ethernet 1/1
Console(config-if)#power inline priority 2
Console(config-if)#
Console#show power inline status
Interface Admin Oper Power(mWatt) Power(used) Priority
---------- ------- ---- ------------ ------------ --------
Eth 1/ 1 enable off 15400 0 low
Eth 1/ 2 enable off 15400 0 low
Eth 1/ 3 enable on 15400 7505 low
Eth 1/ 4 enable off 15400 0 low
Eth 1/ 5 enable off 15400 0 low
Eth 1/ 6 enable off 15400 0 low
Eth 1/ 7 enable on 15400 8597 low
.
.
.
Eth 1/23 enable off 15400 0 low
Eth 1/24 enable off 15400 0 low
Console#