Authentication Commands
4-75
4
Authentication Commands
You can configure this switch to authenticate users logging into the system for
management access using local or remote authentication methods. You can also
enable port-based authentication for network client access using IEEE 802.1X.
User Account Commands
The basic commands required for management access are listed in this section.
This switch also includes other options for password checking via the console or a
Telnet connection (page 4-29), user authentication via a remote authentication
server (page 4-75), and host access authentication for specific ports (page 4-98).
Authentication Protocol The authentication protocol used with SNMPv3.
Privacy Protocol The privacy protocol used with SNMPv3.
Storage Type The storage type for this entry.
Row Status The row status of this entry.
SNMP remote user A user associated with an SNMP engine on a remote device.
Table 4-26 Authentication Commands
Command Group Function Page
User Accounts Configures the basic user names and passwords for management
access
4-75
Authentication Sequence Defines logon authentication method and precedence 4-78
RADIUS Client Configures settings for authentication via a RADIUS server 4-80
TACACS+ Client Configures settings for authentication via a TACACS+ server 4-83
Web Server Enables management access via a web browser 4-85
Telnet Server Enables management access via Telnet 4-88
Secure Shell Provides secure replacement for Telnet 4-89
Port Authentication Configures host authentication on specific ports using 802.1X 4-98
Management IP Filter Configures IP addresses that are allowed management access 4-107
Table 4-27 User Access Commands
Command Function Mode Page
username Establishes a user name-based authentication system at
login
GC 4-76
enable password Sets a password to control access to the Privileged Exec
level
GC 4-77
Table 4-25 show snmp user - display description (Continued)
Field Description
To Next Page
Loading...
Need help?
General