Command Line Interface
4-28
4
Example
The following example shows how to display all file information.
whichboot
This command displays which files were booted when the system powered up.
Command Mode
Privileged Exec
Example
This example shows the information displayed by the whichboot command. See
the table under the dir command for a description of the file information displayed by
this command.
boot system
This command specifies the image used to start up the system.
Syntax
boot system {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom* - Boot ROM.
• config* - Configuration file.
• opcode* - Run-time operation code.
• filename - Name of the configuration file or image name.
* The colon (:) is required.
Default Setting
None
Console#dir
File name File type Startup Size (byte)
------------------------------------- -------------- ------- ----------
Unit1:
diag.bix Boot-Rom Image Y 1286876
es4524m-poe_fw1005.bix Operation Code Y 3489580
Factory_Default_Config.cfg Config File N 455
startup1.cfg Config File Y 4085
--------------------------------------------------------------------------
Total free space: 2359296
Console#
Console#whichboot
File name File type Startup Size (byte) -> align?
-------------------------------- -------------- ------- -----------
Unit1:
diag.bix Boot-Rom Image Y 1286876
es4524m-poe_fw1005.bix Operation Code Y 3489580
startup1.cfg Config File Y 4085
Console#
To Next Page
Loading...
Need help?
General